Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the generator and secure the generator with 3 bolts.
Tighten: Tighten the generator bolts to 50 N.m (37 lb ft).
Connect the battery positive cable to the generator and secure the positive cable with the nut (1).
Tighten: Tighten the generator positive cable nut to 9 N.m (80 lb in).

Fig 1: Rear Of Generator (Alternator) View
Courtesy of GENERAL MOTORS CORP.
Install the engine lift hook and secure the lift hook with 2 bolts.
Tighten: Tighten the bolts to 50 N.m (37 lb ft).

Fig 2: View Of Engine Lift Hook
Courtesy of GENERAL MOTORS CORP.
Install the A/C line bracket to the lift hook and secure the bracket with the bolt.
Tighten: Tighten the A/C line bracket bolt to 10 N.m (89 lb in).

Fig 3: View Of Engine Lift Hook
Courtesy of GENERAL MOTORS CORP.
Install the drive belt. Refer to DRIVE BELT REPLACEMENT in Engine Mechanical - 4.2L.
Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .