Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1351 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Throttle Position (TP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Throttle Body, TP Sensor And Throttle Shaft
    GM850215Courtesy of GENERAL MOTORS CORP.
  1. Align the throttle shaft (3) with the slot in the TP sensor (2).
  2. Install the TP sensor (2) to the throttle body (1).
    3. Fig 2: Inlet Air Duct, TP Sensor, Fasteners
    GM229615Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Secure the TP sensor with the 2 fasteners (3).

    Tighten:  Tighten the fasteners to 2.0 N.m (18 lb in).

  4. Install the inlet air duct to the air cleaner and the throttle body.
scientia non olet · About Mike's Workshop Manuals