Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Grounding Nuts, Bolts, And Battery Cables

Courtesy of GENERAL MOTORS CORP.

Position the positive (+) battery cable (4) into the vehicle.
Route the positive (+) cable into the harness loom.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Connect the cable to the starter solenoid. Secure the cable with the retaining nut.
Tighten: Tighten the positive (+) battery cable-to-starter solenoid retaining nut to 9 N.m (78 lb in).
Install the battery positive fuse block feed cable to positive (+) battery cable. Secure with the nut (5).
Tighten: Tighten the positive (+) battery cable-to- relay block 1 feed cable retaining nut to 9 N.m (78 lb in).
Tape the loom to prevent dirt and moisture from entering the harness.
Install the positive (+) battery cable harness loom to the harness retainers.
Install the plastic insulator to the positive (+) battery cable.
Install the battery to the vehicle. Refer to Battery Replacement .