Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 1994 >> Forward Control 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - Basic Testing - Gasoline) >> C-4, Basic Ignition System Checks >> HEI-Est Distributor >> Tach Pulse (RPM) Signal

Tach Pulse (RPM) Signal

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Connect scan tester to DLC. RPM should be indicated on tester when engine is cranked or running. Tach pulse (RPM reference) will be indicated as a voltage signal when a DVOM connected to battery voltage is used to backprobe circuit No. 430, ECM terminal. See Figure-Figure . If tach pulse signal is not present, vehicle will not run.

scientia non olet · About Mike's Workshop Manuals