Retrieving Codes (Non-Scan)
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, 1994 GMC Rally Camper Special, and 1994 GMC Rally. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Assembly Line Data Link (ALDL) connector may also be referred to as the Data Link Connector (DLC) in flow charts. This is the same connector.
- Turn ignition on with engine off. Malfunction Indicator Light (MIL) should glow. Locate Data Link Connector (DLC), attached to ECM wiring harness. Most DLCs are located under dash on driver's side of vehicle. For exact location of DLC, see appropriate COMPONENT LOCATIONS illustration in appropriate I - SYS/COMP TESTS article in the ENGINE PERFORMANCE section below. Turn ignition on. Insert jumper wire from terminal "B" (diagnostic test terminal) to terminal "A" (ground) of DLC. See Fig 1.
- SYSTEM/COMPONENT TESTS - GASOLINE (for "C" & "K" Series)
- SYSTEM/COMPONENT TESTS - GASOLINE (For "G" & "P" Series)NOTE: Inserting jumper wire into test and ground terminals of DLC with engine running will cause fuel-injected vehicles to enter field service mode and codes will not flash. See FIELD SERVICE MODE in appropriate BASIC TESTING article in the ENGINE PERFORMANCE section below.
- BASIC TESTING - GASOLINE (for "C" & "K" Series)
- BASIC TESTING - GASOLINE (For "G" & "P" Series)
- Malfunction Indicator Light (MIL) should flash codes. Each code is flashed 3 times. If codes DO NOT flash, perform DIAGNOSTIC CIRCUIT CHECK in appropriate BASIC TESTING article in the ENGINE PERFORMANCE section above. To exit diagnostic mode, turn ignition off and remove jumper wire from DLC.