Code 24, VSS Transmission Output Signal "G" Series: Notes
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 1994 GMC Yukon, 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, and 1994 GMC Rally Camper Special. However, it is still accessible from the selected car via links, so may be relevant.
VSS output sensor is a magnetic induction type. Gear teeth pressed on outside diameter of output carrier assembly induce an alternating current in sensor when drive wheels are turning. Since vehicle speed is taken from transfer case on 4WD vehicles, output speed sensor signal on these units goes directly to PCM. Code 24 will set if gear selector is not in Park or Neutral, engine speed is at least 3000 RPM and output speed is less than 250 RPM for at least 1.5 seconds.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Test verifies VSS voltage at PCM.
- Test checks VSS buffer ground circuit.
- Test checks VSS circuit at buffer module.
- Test verifies VSS signal at sensor.