Manifold Absolute Pressure (MAP) Sensor

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

MAP sensor measures changes in manifold pressure. Changes in manifold pressure result from engine load and speed changes. The MAP sensor converts these changes in manifold pressure into a voltage output signal to PCM (1.5 volts at idle to about 4.5 volts at WOT). The PCM can monitor these signals and adjust air/fuel ratio and ignition timing under various operating conditions.

If MAP sensor fails, the PCM substitutes a fixed MAP value, and uses the TP sensor to control fuel delivery. A fault in the MAP circuit should set a related trouble code. If a related trouble code is not present and MAP sensor is suspected of causing a driveability problem, perform functional check of MAP sensor. See SYSTEM/COMPONENT TESTS - GASOLINE article in the ENGINE PERFORMANCE section.