Pinpoint Test I: P1001
- Normal Operation and Fault Conditions
REFER to: Starting System - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM P1001:00 KOER Not Able to Complete, KOER Aborted: No Sub Type Information This DTC sets when the KOER self-test does not complete in the time allowed. Possible Causes
- Incorrect self-test procedure
- Unexpected response from the self-test monitors
- RPM out of specification
- I1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)
- Place the ignition switch in the START position.
- Using a diagnostic scan tool retieve and and record all DTC s.
- Repair any self-test or CMDTC s and clear the DTC s.
- Rerun the KOER self test.
Did DTC P1001 return?
Yes GO to I2 No The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. - I2 REPROGRAM THE PCM
- Reprogram the PCM with the latest software. REFER to: Module Programming
- Rerun the KOER self test.
Did DTC P1001 return?
Yes
Guided Routine (PCM) only available in the on-line Service InformationNo The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.