SECM Guided Routine Testing -- Ford

• DTC/Symptom Selection
  • DTC Index
    • SECM - Steering Effort Control Module
      • DTC B135C: Heater Element
      • DTC B137F: Steering Wheel Left Switch Pack
      • DTC B1380: Steering Wheel Right Switch Pack
      • DTC B13BD: Steering Wheel Heater Module
        • Action
      • DTC C100B: Motor Drive Current
        • Action
      • DTC C100C: Steering Tracking
      • DTC C1039: Active Front Steering (AFS) Lock: Emergency Position Not Reachable
      • DTC C1B00: Steering Angle Sensor
      • DTC C2003: Steering Wheel Switch Left Module
        • Action
      • DTC C200D: Motor Rotation Angle Sensor
      • DTC U0001: High Speed CAN Communication Bus
        • Action
      • DTC U0100: Lost Communication With ECM/PCM "A"
        • Action
      • DTC U0121: Lost Communication With Anti-Lock Brake System (ABS) Control Module
        • Action
      • DTC U0126: Lost Communication With Steering Angle Sensor Module
        • Action
      • DTC U0131: Lost Communication With Power Steering Control Module
        • Action
      • DTC U0146: Lost Communication With Gateway "A"
        • Action
      • DTC U0151: Lost Communication With Restraints Control Module
        • Action
      • DTC U0212: Lost Communication With Steering Column Control Module
        • Action
      • DTC U023A: Lost Communication With Image Processing Module A
        • Action
      • DTC U0401: Invalid Data Received from ECM/PCM "A"
      • DTC U0415: Invalid Data Received From Anti-Lock Brake System (ABS) Control Module
      • DTC U0420: Invalid Data Received From Power Steering Control Module
        • Action
      • DTC U0428: Invalid Data Received From Steering Angle Sensor Module
        • Action
      • DTC U0452: Invalid Data Received From Restraints Control Module
        • Action
      • DTC U0556: Invalid Data Received From Front Display Interface Module
        • Action
      • DTC U0557: Invalid Data Received From Front Controls Interface Module "A"
        • Action
      • DTC U1000: Solid State Driver Protection Active - Driver Disabled
        • Action
      • DTC U2000: Motor Temperature
      • DTC U2001: Reduced System Function
      • DTC U2002: Switch
      • DTC U2011: Motor
        • Action
      • DTC U2016: Control Module Main Software
        • Action
      • DTC U201A: Control Module Main Calibration Data
        • Action
      • DTC U2100: Initial Configuration Not Complete
        • Action
      • DTC U2101: Control Module Configuration Incompatible
        • Action
      • DTC U210A: Temperature Sensor
      • DTC U3000: Control Module
      • DTC U3003: Battery Voltage
  • Symptom Chart - Adaptive Steering System
    • Notes
    • A Module Does Not Respond To The Diagnostic Scan Tool
    • Click Noise With Or Without Steering Wheel Movement During Vehicle Startup Or Shutdown
    • Front Wheel Contacting Suspension Control Arm
    • High Steering Effort
    • The Red Adaptive Steering System Warning Indicator Is Always On
    • The Yellow Adaptive Steering System Warning Indicator Is Always On
    • The Yellow Adaptive Steering System Warning Indicator Flashes Once Per Second During Start Up
    • Message Center Displays Adaptive Steering Initialization
    • Message Center Displays Adaptive Steering Off Service Required
    • Message Center Displays Adaptive Steering Loss Do Not Drive
    • Steering Tie-Rods Adjusted Unevenly
    • Steering Wheel Is Off Center (Clearvision Is Outside Of Expected Parameters)
    • Steering Wheel Is Off Center Following Adaptive Steering Trim Service Routines
    • Turn Signals Cancel Unevenly
    • Uneven Steering Wheel Rotation Lock-To-Lock
• Pinpoint Tests
  • Pinpoint Tests A: SECM Low Voltage Concern
    • Notes
    • Normal Operation and Fault Conditions
    • Possible Causes
    • Visual Inspection and Diagnostic Pre-checks
  • Pinpoint Tests B: SECM High Voltage Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests C: Lost Communication With PCM Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests D: Lost Communication With ABS Module Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests E: Lost Communication With SASM Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests F: Lost Communication with PSCM Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests G: Lost Communication with GWM Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests H: Lost Communication With RCM Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests I: SECM Motor Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests J: SECM Internal Fault Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests K: Steering Lock Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests L: SECM High Current Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests M: SECM Temperature Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests N: SECM Configuration Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests O: Lost Communication With SCCM Concern
    • Normal Operation and Fault Conditions
    • Possible Causes
  • Pinpoint Tests P: Lost Communication With Image Processing Module A Concern
    • Normal Operation and Fault Conditions
    • Possible Causes