Restraints Control Module (RCM): Removal

WARNING: This page is about a different car, the 2022 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: This step is only necessary when installing a new component.

NOTE: The PMI (programmable module installation) process must begin with the current RCM (restraints control module) installed. If the current RCM (restraints control module) does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

Using a diagnostic scan tool, begin the PMI process for the RCM following the on-screen instructions.
Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .
Remove the floor console. Refer to: Floor Console .
Remove the screws and the floor console mounting bracket.
Torque

: 93 lb.in (10.5 Nm)

Courtesy of FORD MOTOR COMPANY
1. Detach the wiring harness retainers.
2. Disconnect the RCM electrical connectors.
Courtesy of FORD MOTOR COMPANY
Remove the retainers and the RCM.
Torque

: 106 lb.in (12 Nm)

Courtesy of FORD MOTOR COMPANY