Battery Energy Control Module B (BECMB): Removal

WARNING: This page is about a different car, the 2022 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash.

WARNING: Before beginning any service procedure in this article, refer to HEALTH AND SAFETY PRECAUTIONS in Service Information/General Information. Failure to follow this instruction may result in serious personal injury.

Refer to: Pyrotechnic Device Health and Safety Precautions .
NOTE: This step is only necessary when installing a new component.

NOTE: The PMI process must begin with the current BECMB installed. If the current BECMB does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

Using a diagnostic scan tool, begin the PMI process for the BECMB following the on-screen instructions.
Depower the SRS. Refer to: Supplemental Restraint System (SRS) Depowering .
1. Lower the glove compartment.
2. Release the check strap.
Courtesy of FORD MOTOR COMPANY
1. Push in and release the glove compartment stops.
2. Lower the glove compartment.
Courtesy of FORD MOTOR COMPANY
1. Disconnect the electrical connector.
2. Remove the pin-type retainers.
3. Remove the BECMB.

Courtesy of FORD MOTOR COMPANY