Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2023 >> Edge ST-Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 1051 (MULTIFUNCTION Electronic Modules) >> Diagnosis And Testing >> Body Control Module (BCM) >> Pinpoint Tests >> Pinpoint Test AE: U3000:49

Pinpoint Test AE: U3000:49

WARNING: This page is about a different car, the 2023 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    The BCM receives voltage at all times from the BJB.

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    BCM U3000:49 Control Module: Internal Electronic Failure This DTC sets when the BCM detects an internal failure.

    Possible Sources 

    • BCM

  2. AE1 CONFIRM THE DTC (DIAGNOSTIC TROUBLE CODE) RESETS

    • Check vehicle service history for recent service actions related to the BCM.

    • Connect the diagnostic tool.

    • Ignition ON.

    • Using the diagnostic scan tool, clear the DTC.

    • Wait 10 seconds.

    • Using the diagnostic scan tool, perform the BCM self-test.

    Is DTC U3000:49 still present? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new BCM. REFER to: Body Control Module (BCM) .
    No  The DTC may have been falsely set.
scientia non olet · About Mike's Workshop Manuals