Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2021 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System (Abs) And Stability Control >> Diagnosis And Testing >> Anti-Lock Brake System (ABS) and Stability Control >> Pinpoint Tests >> Pinpoint Test P: Pats Target Identifier

Pinpoint Test P: Pats Target Identifier

  1. Normal Operation and Fault Conditions 

    The ABS module and BCM share a secret code (target identifier) when the ignition is set to ON. This code is generated during the PATS programming procedure. If either a new BCM or a new ABS module has been installed, the PATS programming procedure must be carried out.

    REFER to: PERIMETER ANTI-THEFT ALARM - SYSTEM OPERATION AND COMPONENT DESCRIPTION .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    ABS B10DA:51 PATS Target Identifier: Not Programmed Sets when the target identifier sent from the BCM does not match the target identifier programmed in the ABS module.

    Possible Sources 

    • Network communication concern
    • BCM programming error
    • ABS module programming error

    Visual Inspection and Pre-checks 

    • Check the vehicle repair history and determine if a new BCM or ABS module has been installed. If a new module has been installed, verify it has been programmed correctly and verify the PATS programming procedure has been carried out.

  2. Diagnostic steps are not provided for this symptom or DTC. REFER to: Diagnostic Methods 

scientia non olet · About Mike's Workshop Manuals