The Line Lock Feature Cannot Be Selected From The Track Application Menu (Grayed Out)

Possible Source	Action
DTCs present in the ABS module, PCM or PSCM Vehicle is on an incline Engine is not running Selectable driving mode is set to Snow-Wet Vehicle is traveling faster than 40-48 km/h (25-30 mph) Lane keep assist feature is enabled Pre-collision assist active braking feature is enabled	Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all ABS module, PCM and PSCM DTCs. The vehicle must be on a flat surface for Line Lock feature use. MOVE vehicle to a flat surface and ATTEMPT to engage the Line Lock feature. START the engine and ATTEMPT to engage the Line Lock feature. The Line Lock feature cannot be used with Snow-Wet mode selected. SELECT Track mode and ATTEMPT to engage the Line Lock feature. The vehicle cannot be moving when selecting the Line Lock feature. STOP the vehicle and ATTEMPT to engage the Line Lock feature. The Line Lock feature cannot be used with Lane Keep Assist feature enabled. DISABLE the Lake Keep Assist feature and ATTEMPT to select the Line Lock feature. The pre-collision assist feature is automatically disabled when the AdvanceTrac system is manually disabled or when Track Mode is selected. RETRIEVE and DIAGNOSE all HUD, CCM, IPMA and ABS module DTCs.

Possible Source

Action

Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all ABS module, PCM and PSCM DTCs.
The vehicle must be on a flat surface for Line Lock feature use. MOVE vehicle to a flat surface and ATTEMPT to engage the Line Lock feature.
START the engine and ATTEMPT to engage the Line Lock feature.
The Line Lock feature cannot be used with Snow-Wet mode selected. SELECT Track mode and ATTEMPT to engage the Line Lock feature.
The vehicle cannot be moving when selecting the Line Lock feature. STOP the vehicle and ATTEMPT to engage the Line Lock feature.
The Line Lock feature cannot be used with Lane Keep Assist feature enabled. DISABLE the Lake Keep Assist feature and ATTEMPT to select the Line Lock feature.
The pre-collision assist feature is automatically disabled when the AdvanceTrac system is manually disabled or when Track Mode is selected. RETRIEVE and DIAGNOSE all HUD, CCM, IPMA and ABS module DTCs.