DTC P2535 - Ignition Switch Run/Start Position Circuit High
DTC DESCRIPTION P2535 - IGNITION SWITCH RUN/START POSITION CIRCUIT HIGH
| Description: The PCM carries out a logic check on the ISP-R and ISP-R/S circuits. This DTC sets when the ISP-R/S circuit stays high longer than a calibrated amount of time, or is high when it is expected to be low. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Monitor the KEYST parameter identifier (PID). The PID should indicate RUN when the ignition is in the ON position and RUN/START when the ignition is in the START position. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST B . | ||