Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2020 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electric Powertrain Control (2 Of 2) >> Diagnosis And Testing >> Electric Powertrain Control >> Pinpoint Tests >> Pinpoint Test F : P060B:47, P060B:62

Pinpoint Test F : P060B:47, P060B:62

  1. NOTE: The Inverter System Controller (ISC) is referred to as the SOBDMC (Secondary On-Board Diagnostic Control Module C) in the scan tool.

    Normal Operation and Fault Conditions 

    REFER to: Electric Powertrain Control - System Operation and Component Description .

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    SOBDMC P060B:47 Internal Control Module A/D Processing Performance: Watchdog/Safety μC Failure This DTC sets when an internal error occurs.
    SOBDMC P060B:62 Internal Control Module A/D Processing Performance: Signal Compare Failure This DTC sets when an internal error occurs.

    Possible Sources 

    • Inverter System Controller (ISC) calibration
    • Intermittent low voltage wiring concern
    • Wiring, terminals or connectors
    • Inverter System Controller (ISC)

  2. F1 CHECK FOR INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.

    Are any Inverter System Controller (ISC) DTCs other than P060B:47 or P060B:62 present? 

    Yes  DIAGNOSE all other Inverter System Controller (ISC) DTCs, REFER to Diagnostic Trouble Code (DTC) Chart .
    No  For DTC P060B:47 or P060B:62 only GO to  F2

  3. F2 VERIFY THE INVERTER SYSTEM CONTROLLER (ISC) CALIBRATION LEVEL

    • Verify the Inverter System Controller (ISC) is at the latest calibration level.

    Is the Inverter System Controller (ISC) at the latest calibration level? 

    Yes  GO to  F3
    No  UPDATE the Inverter System Controller (ISC) to the latest calibration level.

  4. F3 CLEAR AND CHECK THE INVERTER SYSTEM CONTROLLER (ISC) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, clear the Inverter System Controller (ISC) DTCs.

    • Using a diagnostic scan tool, perform the Inverter System Controller (ISC) self-test.

    Are DTCs P060B:47 or P060B:62 present in the Inverter System Controller (ISC)? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new Inverter System Controller (ISC). REFER to: Inverter System Controller [SOBDMC] .
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About Mike's Workshop Manuals