Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2020 >> Edge ST-Line, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Fuel Charging And Controls - 2.7L ECOBOOST (238KW/324PS)) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Installation

Fuel Pump Driver Module (FPDM): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Connect the fuel pump driver module electrical connector.
    GFD526561Courtesy of FORD MOTOR COMPANY
  2. Install the fuel pump driver module, then install and tighten the fuel pump driver module nuts.

    Torque: 36 lb.in (4.1 Nm)

    GFD526560Courtesy of FORD MOTOR COMPANY
  3. Position back the EVAP blocking valve and hoses.
GFD526559Courtesy of FORD MOTOR COMPANY
scientia non olet · About Mike's Workshop Manuals