Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2019 >> Transit-150 Base, 3.7L Eng VIN M, Gas >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Engine Controls - 3.7L DURATEC (199KW/270PS) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description .

  3. NOTE: This step is only necessary when installing a new component.
    NOTE: Vehicles without PATS may still require a parameter reset.

    Carry out the Parameter Reset procedure. Refer to: Passive Anti-Theft System (PATS) Parameter Reset .

  4. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

scientia non olet · About Mike's Workshop Manuals