Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2018 >> Mustang EcoBoost, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> DTC Index (Engine Cooling System - Parking Aid System) >> Exterior Lighting System DTCS >> DRL

Exterior Lighting System DTCS: DRL

DTC INDEX

DTC Description Action
B124A:11 Right Daytime Running Light: Circuit Short To Ground GO to PINPOINT TEST A : THE DRL (DAYTIME RUNNING LAMPS) ARE INOPERATIVE - WITHOUT SVT PERFORMANCE PACKAGE
B124A:15 Right Daytime Running Light: Circuit Short To Battery or Open If the lamp is inoperative, GO to PINPOINT TEST A : THE DRL (DAYTIME RUNNING LAMPS) ARE INOPERATIVE - WITHOUT SVT PERFORMANCE PACKAGE
If the lamp is always on, GO to PINPOINT TEST B : THE DRL (DAYTIME RUNNING LAMPS) ARE ALWAYS ON - WITHOUT SVT PERFORMANCE PACKAGE
B124B:11 Left Daytime Running Light: Circuit Short To Ground GO to PINPOINT TEST A : THE DRL (DAYTIME RUNNING LAMPS) ARE INOPERATIVE - WITHOUT SVT PERFORMANCE PACKAGE
B124B:15 Left Daytime Running Light: Circuit Short To Battery or Open If the lamp is inoperative, GO to PINPOINT TEST A : THE DRL (DAYTIME RUNNING LAMPS) ARE INOPERATIVE - WITHOUT SVT PERFORMANCE PACKAGE
If the lamp is always on, GO to PINPOINT TEST B : THE DRL (DAYTIME RUNNING LAMPS) ARE ALWAYS ON - WITHOUT SVT PERFORMANCE PACKAGE
U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test.
U3000:49 Control Module: Internal Electronic Failure The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, Refer to BCM GUIDED ROUTINE TESTING
For other BCM Diagnostic Trouble Codes (DTCs) - REFER to: Body Control Module (BCM) .