Pinpoint Test U : C113A:12: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Charging System for schematic and connector information.
Normal Operation and Fault Conditions
The PCM receives a wake-up signal from the BECM. The PCM sets a DTC if voltage on this input is above a calibrated threshold.
Possible Sources
- Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
- BECM
- PCM
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C113A:12 | Wakeup Control | The vehicle is not in park and the PCM detects a voltage input greater than 3.55 volts. |