Pinpoint Test Ag : U016A:00: Notes

WARNING: This page is about a different variant/trim than selected.

Refer to Module Communications Network for schematic and connector information.

Normal Operation and Fault Conditions

The PCM continuously monitors the CAN for messages from the GPS module. This DTC sets when the PCM does not receive the GPS module message within the defined amount of time.

Possible Sources

Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
Communication error
Low battery condition
Battery recently replaced
BCM fuse 67 (7.5A)
GPS module
PCM

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
U016A:00	Lost Communication With The Global Positioning System (GPS) Module	After the PCM, GPS module wake up the PCM did not detect a response from the GPS module.