Without Sync: FCDIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| C1001:01 | Vision System Camera: General Electrical Failure | REFER to: Parking Aid . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test M |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test O |
| U0159:00 | Lost Communication With Parking Assist Control Module "A": No Sub Type Information | GO to Pinpoint Test P |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test Q |
| U0256:00 | Lost Communication With Front Controls Interface Module "A": No Sub Type Information | GO to Pinpoint Test R |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incorrect or incomplete FCDIM configuration. CARRY OUT the FCDIM PMI procedure using as-built data. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete FCDIM configuration. CARRY OUT the FCDIM PMI procedure using as-built data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incorrect or incomplete FCDIM configuration. CARRY OUT the FCDIM PMI procedure using as-built data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds and then REPEAT the self-test. If the DTC is retrieved again, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTC. WAIT at least 10 seconds and then REPEAT the self-test. If the DTC is retrieved again, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test T |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test U |