Removal And Installation

WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear .

2.

Release part of the close-out trim cover at the bottom LH side and position aside.

3.

Release the bottom LH cushion trim cover J-clip.

4.

Disconnect the 2 electrical connectors, remove the scrivet and heated seat module.

5.

To install, reverse the removal procedure.

6.

Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
- Start the vehicle and push the low button on either heated seat switch.
- Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.