P1A08 - Generator Mode Signal
P1A08 - GENERATOR MODE SIGNAL
| Description: | The TCM continuously monitors the controller area network (CAN) communication bus for a generator mode message from the PCM. This DTC sets when the received message does not match the actual generator mode. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the SOBDMC is at the latest calibration level. Clear the SOBDMC DTCs. Repeat the self-test. If the DTC is retrieved again, install a new TCM. Refer to the Service Information, Automatic Transmission. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||