Information System And Entertainment System (SONY 8 Inch Touchscreen 12 Speakers) DTCS: FCIM

DTC INDEX

DTC	Description	Action
B00D5:01	Restraint System Passenger Disable Indicator: General Electrical Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC B00D5:01 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
B113C:11	Hazard Switch Illumination: Circuit Short To Ground	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC B00D5:01 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
B1202:01	Restraint System Passenger Enable Indicator: General Electrical Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC B00D5:01 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U0155:00	Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information	GO to Pinpoint Test AG .
U0257:00	Lost Communication With Front Controls/Display Interface Module: No Sub Type Information	GO to Pinpoint Test AM .
U0423:00	Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information	RETRIEVE and FOLLOW DTCs present in the IPC. REFER to Instrumentation, Message Center, and Warning Chimes . If there are no DTCs present in the IPC, DIAGNOSE the observable symptom.
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	GO to Pinpoint Test Y .
U3000:41	Control Module: General Checksum Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to Pinpoint Test AN .
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to Pinpoint Test AP .