Fuel Pump Driver Module (FPDM): Removal
- 1.NOTE: Removal steps in this procedure may contain installation details.NOTE: The FPDM is located under the carpet and under left front seat attached to the rear of the front cross floor support in front of the left front seat.
Refer to: Fuel Charging and Controls - Component Location .
- 2.
Remove the LHF front seat. Refer to: Front Seat .
- 3.
Remove the lower LH B-Pillar trim panel and front sill plate. Refer to: B-Pillar Trim Panel .
- 4.NOTE: To avoid damage to the trim panels, remove any retaining clips from the body and attach them to the trim panels before installing.
Remove the retainer and then remove the LHF front kick panel.
- 5.
- 1.
Disconnect the FPDM wire connector.
- 2.
Remove the FPDM retaining nuts and then remove the FPDM.Torque: 44 lb.in (5 Nm)
- 1.