In-Vehicle Repair: Flexplate: Installation

WARNING: This page is about a different car, the 2016 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Install the flexplate and the 8 bolts.
- Tighten in the sequence shown in illustration to 80 Nm (59 lb-ft).

Fig 1: Flexplate Bolts Tightening Sequence

Courtesy of FORD MOTOR COMPANY

2.

Install the transaxle. For additional information, refer to Automatic Transmission - 6F50/6F55 .

3.

After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.