Powertrain Control Module (PCM): Installation
WARNING: This page is about a different variant/trim than selected.
- 1.
- To install, reverse the removal procedure.
- Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
- 2.NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. REFER to: Module Configuration - System Operation and Component Description .
Use the General Equipment: Ford Diagnostic Equipment
- 3.NOTE: This step is only necessary when installing a new component.
Reprogram the Passive Anti-Theft System (PATS). REFER to: Anti-Theft Security Access - Vehicles With: Keyless Vehicle System.