Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2017 >> Edge SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Cooling System - 2.7L ECOBOOST (238KW/324PS)) >> Removal And Installation >> Cooling Module >> Installation

Cooling Module: Installation

WARNING: This page is about a different variant/trim than selected.

  1. 1.

    To install, reverse the removal procedure.

  1. 2.

    NOTE: Only use the specified material to lubricate the seals.

    Install new condenser fitting O-ring seals.

    Material: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)

  1. 3.

    Fill and bleed the cooling system. REFER to: Cooling System Draining and Vacuum Filling .

  1. 4.

    Check and fill the transmission fluid as necessary. REFER to: Transmission Fluid Level Check .
scientia non olet · About Mike's Workshop Manuals