Repair procedures: Installation
WARNING: This page is about a different car, the 2014 Hyundai Elantra GT and 2013 Hyundai Elantra GT. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least three minutes.
- Connect the knee airbag connector.
- Tighten the knee airbag mounting bolt and nuts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
- Install the crash pad lower panel.
(Refer to "CRASH PAD LOWER PANEL ")
- Reconnect the battery negative cable.
- After installing the knee airbag, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.