Without Sync: FCDIM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| C1001:01 (only for vehicles that display the rear video camera image in the FCDIM) | Vision System Camera: General Electrical Failure | REFER to: Parking Aid - Vehicles With: Parking Aid Camera. See FCDIM DTC Chart. |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test P |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test Q |
| U0159:00 | Lost Communication With Parking Assist Control Module "A": No Sub Type Information | GO to Pinpoint Test R |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test S |
| U0256:00 | Lost Communication With Front Controls Interface Module "A": No Sub Type Information | GO to Pinpoint Test T |
| U2013:87 | Switch Pack: Missing Message | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:87 is retrieved again, INSTALL a new FCDIM. Refer to: Front Control/Display Interface Module (FCDIM) . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incorrect or incomplete FCDIM configuration. Using a diagnostic scan tool, PERFORM the FCDIM programming procedure using as-built data. For information on as-built data, Refer to: Module Configuration - System Operation and Component Description . See As-Built Data. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete FCDIM configuration. Using a diagnostic scan tool, PERFORM the FCDIM programming procedure using as-built data. For information on as-built data, Refer to: Module Configuration - System Operation and Component Description . See As-Built Data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incorrect or incomplete FCDIM configuration. Using a diagnostic scan tool, PERFORM the FCDIM programming procedure using as-built data. For information on as-built data, Refer to: Module Configuration - System Operation and Component Description . See As-Built Data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCDIM. Refer to: Front Control/Display Interface Module (FCDIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCDIM. Refer to: Front Control/Display Interface Module (FCDIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test V |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test W |