Touchscreen Display: FCIMB
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B00D5:01 | Restraint System Passenger Disable Indicator: General Electrical Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC B00D5:01 is retrieved again, INSTALL a new FCIMB. Refer to: Front Controls Interface Module B (FCIMB) . |
| B1202:01 | Restraint System Passenger Enable Indicator: General Electrical Failure | CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC B1202:01 is retrieved again, INSTALL a new FCIMB. Refer to: Front Controls Interface Module B (FCIMB) . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AF |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test AH |
| U0165:00 | Lost Communication With HVAC Control Module - Rear: No Sub Type Information | GO to Pinpoint Test AK |
| U0422:00 | Invalid Data Received from Body Control Module: No Sub Type Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the BCM. Refer to: BODY CONTROL MODULE (BCM) .* If no Diagnostic Trouble Codes (DTCs) are present in the BCM, DIAGNOSE the observable symptom. |
| U2013:63 | Switch Pack: Circuit / Component Protection Time-Out | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIMB. Refer to: Front Controls Interface Module B (FCIMB) . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incorrect or incomplete FCIMB configuration. Using a diagnostic scan tool, PERFORM the FCIMB programming procedure using as-built data. For information on as-built data, Refer to: Module Configuration - System Operation and Component Description . See As-Built Data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIMB. Refer to: Front Controls Interface Module B (FCIMB) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIMB. Refer to: Front Controls Interface Module B (FCIMB) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AO |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AP |
| U3009:01 | Control Module Ground "B": General Electrical Failure | For a low battery voltage concern, GO to Pinpoint Test AO For a high battery voltage concern, GO to Pinpoint Test AP |