Remote Keyless Entry (RKE) Transmitter Programming

Programming

NOTE: All RKE transmitters must be programmed at the same time. Entering the programming mode erases all previously programmed RKE transmitters (Integrated Keyhead Transmitters (IKTs) and key fobs). If equipped with a PATS, the PATS portion of the programmed Integrated Keyhead Transmitters (IKTs) is unaffected.

1.

Use the door lock control switch to unlock the doors.

2.

Cycle the ignition from OFF to RUN to OFF 4 times in rapid succession (within 6 seconds), with the last turn ending in OFF. If the module successfully enters program mode, a chime sounds.

3.

NOTE: Programming mode ends when:
- the ignition transitions ON.
- 10 seconds elapse since entering programming mode or since the last RKE transmitter was programmed (a chime sounds to confirm that programming is complete).
Within 10 seconds, press and hold any button on the RKE transmitter to be programmed until a chime sounds to confirm the RKE transmitter is programmed. Repeat this step for each RKE transmitter. A maximum of 8 RKE transmitters can be programmed to the vehicle.

4.

Check the operation of the RKE transmitters. If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and press the button again. If the door locks still fail to respond, diagnose the RKE transmitter(s).