Fuel Pump Driver Module (FPDM): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: Removal steps in this procedure may contain installation details.

Vehicles with rear bench seat

NOTE: When installing the seat cushion, press firmly downward until an audible click is heard.

Vehicles with split rear seat backrest
Position the RH front seat all of the way forward.
Raise the RH rear seat cushion and fold forward.
Remove the RH Outboard safety belt lower anchor bolt.
Torque : 30 lb.ft (40 Nm)

All vehicles
NOTE: The FPDM is held in place with an adhesive backing.