Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2013 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System And Stability Control >> Removal And Installation >> Wheel Speed Sensor Ring - Rear >> Removal

Wheel Speed Sensor Ring - Rear: Removal

  1. Remove the rear axle shaft. For additional information, refer to REAR DRIVE AXLE/DIFFERENTIAL - FORD 8.8-INCH RING GEAR .
  2. Using the Pinion Bearing Cone Remover, remove the anti-lock brake sensor indicator from the axle shaft.
    Fig 1: Removing Anti-Lock Brake Sensor Indicator From Axle Shaft Using Pinion Bearing Cone Remover
    G06403287Courtesy of FORD MOTOR CO.
scientia non olet · About Mike's Workshop Manuals