Transmission - Overhaul: Notes
WARNING: This page is about a different variant/trim than selected.
SPECIAL TOOL(S) DESCRIPTION
| Actuator Pin 303-D011 (D80L-100-G) |
|
| Collet, 3/4 Inch to 7/8 Inch 303-D019 (D80L-100-Q) |
|
| Compressor, Center Support Piston Spring 307-630 |
|
| Compressor, Forward Clutch Spring 307-574 (includes 307-574/1 and 307-574/2) |
|
| Compressor, Forward/Intermediate Spring 307-584 (includes 307-584/1 and 307-584/2) |
|
| Compressor, Overdrive Clutch, Balance Piston and Direct Clutch 307-589 (includes 307-589/1 and 307-589/2) |
|
| Dial Indicator Gauge With Holding Fixture 100-002 (TOOL-4201-C) |
|
| Handle 205-153 (T80T-4000-W) |
|
| Handle, Torque Converter 307-091 (T81P-7902-C) |
|
| Holding Fixture 307-625 |
|
| Holding Fixture, Transmission 307-003 (T57L-500-B) |
|
| Input Shaft Support Seal Installer (Back Plate, Multiple Rings) 307-578 (includes 307-578/1, 307-578/2 and 307-578/3) |
|
| Installer, Axle Seal 307-718 |
|
| Installer, Converter Seal 307-627 |
|
| Installer, Differential Seal 307-626 |
|
| Manual Lever Seal Installer 307-581 |
|
| Remover, Roll Pin 211-061 (T78P-3504-N1) |
|
| Retainer, Torque Converter 307-566 |
|
| Slide Hammer 100-001 (T50T-100-A) |
|
| Seal Installer, Turbine Shaft 307-634 |
|
| Seal Protector, 2-6 Piston 307-632 |
|
| Seal Protector, Low Reverse Piston 307-628 (includes 307-628/1 and 307-628/2) |
|
| Seal Protector, Low Reverse/1-2-3-4 Piston 307-629 |
|
| Seal Protector, Turbine Shaft 307-635 |
|
| Shim Selection Gauge 307-300 (T94P-77000-Q) (17-055) |
|
| Spring Compressor, 2-6 Piston Return 307-633 (Includes 307-633/1 and 307-633/2) |
MATERIAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Motorcraft® MERCON® LV Automatic Transmission Fluid XT-10-QLVC (US); CXT-10-LV12 (Canada) |
MERCON® LV |
| Ultra Silicone Sealant TA-29 |
- |