Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2013 >> Escape Titanium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Anti-Lock Brake System (Abs) And Stability Control) >> Removal And Installation >> Wheel Speed Sensor - Front >> Installation

Wheel Speed Sensor - Front: Installation

WARNING: This page is about a different car, the 2014 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front wheel speed sensor and install the front wheel speed sensor bolt.
    • Tighten to 15 Nm (133 lb-in).
  2. Attach the 2 grommets to the routing brackets.
  3. Attach the 2 pin-type retainers.
  4. Connect the wheel speed sensor electrical connector.
  5. Install the fender splash shield. REFER to FENDER SPLASH SHIELD
  6. Install the wheel and tire. REFER to WHEEL AND TIRE
scientia non olet · About Mike's Workshop Manuals