| C0061:28, C0062:28, C0063:28, C0064:28 |
Lateral Acceleration, Longitudinal Acceleration, Yaw Rate, Roll Rate Sensor: Signal Bias Level Out of Range/Zero Adjustment Failure |
This DTC
sets in continuous memory and on-demand if the sensor signal is greater than the programmed sensor maximum plausible signal. |
| C0061:2F, C0063:2F |
Lateral Acceleration, Yaw Rate Sensor: Signal Erratic |
This DTC
sets in continuous memory and on-demand if the sensor signal is out of range when the vehicle is standing still. |
| C0061:64, C0062:64, C0063:64, C0064:64 |
Lateral Acceleration, Longitudinal Acceleration, Yaw Rate, Roll Rate Sensor: Signal Plausibility Failure |
This DTC
sets in continuous memory and on-demand if the lateral acceleration sensor signal does not match the other stability sensor signals (steering angle, yaw rate, longitudina acceleration, etc.). |
| U0028:88 |
Vehicle Communication Bus "A": Bus Off |
This DTC
sets in continuous memory and on-demand due to a circuit failure in the private High Speed Controller Area Network (HS-CAN) between the ABS
module and the RCM
. |
| U0151:00 |
Lost Communication With Restraints Control Module: No Sub Type Information |
This DTC
sets in continuous memory and on-demand if the expected RCM
messages such as yaw rate sensor, lateral and longitudinal accelerometers are missing for more than 5 seconds. |
| U0452:86 |
Invalid Data Received from Restraints Control Module: Signal Invalid |
This DTC
sets in continuous memory and on-demand if one or more of the stability sensors inside the RCM
fails and the sensor signal provided does not match other vehicle dynamic sensor input. |