Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Transit Connect Base, Van Cargo >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission (4F27E) >> Disassembly And Assembly Of Subassemblies >> Final Drive Carrier and Differential Assembly >> Assembly

Final Drive Carrier and Differential Assembly: Assembly

  1. Lubricate the gears and thrust washers with clean transmission fluid.
    Fig 1: Locating Gears And Thrust Washers
    G06292974Courtesy of FORD MOTOR CO.
  2. Install the different pinion gears and thrust washers.
    1. Install the differential side gears and thrust washers.
    2. Install the differential pinion gears and thrust washers by rotating 90 degrees.
      Fig 2: Identifying Differential Side Gears And Differential Pinion Gears
      G06292975Courtesy of FORD MOTOR CO.
    3. NOTE: Install a new roll pin.
  3. Install the differential pinion shaft.
    1. Install the pinion shaft.
    2. Install the roll pin.
      Fig 3: Identifying Pinion Shaft And Roll Pin
      G06292976Courtesy of FORD MOTOR CO.
    4. NOTE: LH shown in illustration, RH similar.
    Fig 4: Installing Differential Case Bearings
    G06292977Courtesy of FORD MOTOR CO.
  4. Using the Differential Bearing Installer, install the differential case bearings.
scientia non olet · About Mike's Workshop Manuals