Side Air Bag Module: Installation
WARNING:
Before installing the seat side air bag module/deployment chute assembly:
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
- Inspect the side air bag module and mounting surfaces for any damage or foreign material.
- Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and the air bag module cavity in the seat backrest foam pad.
- Install new parts if damaged.
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
WARNING:
If the seat side air bag module deployment chute is not correctly positioned, the seat side air bag may not deploy correctly. Failure to follow this instruction may result in the seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
NOTE:
If a side air bag deployment took place, a new seat backrest pad, trim cover, side air bag module and nuts must be installed. A new backrest frame should be installed if necessary.
- Install the side air bag module in the following sequence:
- Install the side air bag module into the deployment chute and position the studs through the holes in the chute and backrest frame.
- Install the 2 side air bag module nuts.
- Tighten to 6 Nm (53 lb-in).
- Connect the electrical connector.
- Close the backrest cover in the following sequence.
- Fasten the upper rear J-clip to the backrest frame.
- Attach the inboard and outboard pin-type retainers to the backrest frame.
- Fasten the inboard and outboard vertical J-strips.
- Fasten all backrest cover strap clips to the springs under the seat.
- Install the seat. For additional information, refer to SEATING .