Removal And Installation

WARNING: This page is about a different car, the 2016 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The Headlamp Control Module (HCM) is located below the LH headlamp assembly.

1.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

2.

Disconnect the HCM electrical connector.

3.

Remove the 2 bolts and the HCM.
- To install, tighten to 8 Nm (71 lb-in).

4.

To install, reverse the removal procedure.