Removal And Installation

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

1.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .

2.

Remove the 4 screws and position aside the fender splash shield.

GFD94637

Courtesy of FORD MOTOR COMPANY

3.

Disconnect the HCM electrical connector.

4.

Remove the 2 bolts and the HCM.
- To install, tighten to 8 Nm (71 lb-in).

5.

To install, reverse the removal procedure.