Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Taurus Limited, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System (Abs) And Stability Control >> Diagnosis And Testing >> Anti-Lock Control >> Pinpoint Tests >> Pinpoint Test F: DTC B2900 >> Pinpoint Test F : DTC B2900

Pinpoint Test F : DTC B2900

  1. F1 VERIFY PCM VIN 
    • Connect the scan tool.
    • Ignition ON.
    • Using the scan tool, carry out the Network Test.
    • Enter the following diagnostic mode on the scan tool: Log Viewer.
    • Compare the VIN in Log Viewer to the VIN plate.
    • Does VIN in Log Viewer match the VIN plate? 
      • Yes  : GO to F2.
      • No  : RECONFIGURE the PCM. FOLLOW the instructions on the scan tool. CLEAR the DTCs. CYCLE the ignition key. REPEAT the self-test.
  2. F2 VERIFY ABS MODULE PART NUMBER 
    • Retrieve and record the ABS module part number from Log Viewer and verify that the vehicle has the correct ABS module installed.
    • Is the correct ABS module installed in the vehicle? 
      • Yes  : CONFIGURE the ABS module. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available . CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.
      • No  : INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) Module  . CLEAR the DTC. CYCLE the ignition key. REPEAT the self-test.
scientia non olet · About Mike's Workshop Manuals