Throttle Position (TP) Sensor - 3.5L GTDI: Installation

WARNING: This page is about a different car, the 2016 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the ETB.

NOTE: Do not use power tools.

Install the new TP sensor.
- Using hand tools, install the 2 new bolts.
  - Tighten to 3 Nm (27 lb-in).

Courtesy of FORD MOTOR COMPANY

2.

Connect the TP sensor electrical connector.

Courtesy of FORD MOTOR COMPANY

3.

Install the CAC outlet pipe. For additional information, refer to Intake Air Distribution and Filtering .