Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - Powertrain DTC Charts & Descriptions (Diesel)) >> Diagnostic Trouble Code (DTC) Charts and Descriptions >> P061A - Internal Control Module Torque Performance

P061A - Internal Control Module Torque Performance

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
P061A - INTERNAL CONTROL MODULE TORQUE PERFORMANCE

Description:  This DTC sets when the PCM when the measured engine torque value exceeds the maximum allowable engine torque value.
Possible Causes: 
  • Aftermarket performance products
  • PCM programming error
Diagnostic Aids:  Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
scientia non olet · About Mike's Workshop Manuals