DTC U2100 Initial Configuration Not Complete: Description
WARNING: This page is about a different car, the 2017 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
When a new EPAS gear is installed, the PSCM must be configured with the vehicle information. Configuration is checked during initial PSCM power up (ignition ON) with the voltage supply to the PSCM greater than 6.5 volts.
- DTC U2100:00 (Initial Configuration Not Complete: No Sub Type Information) - This DTC is set if the PSCM detects the vehicle data configuration or the component base data configuration is missing or incomplete. This usually occurs when the initial PSCM configuration is not carried out or if the configuration fails.
- DTC U2100:55 (Initial Configuration Not Complete: Not Configured) - This DTC is pre-set in a new PSCM and is cleared once a successful module configuration has been carried out.