DTC P2195: O2 Sensor Signal Biased/Stuck Lean - Bank 1, Sensor 1

P2195 - O2 SENSOR SIGNAL BIASED/STUCK LEAN - BANK 1, SENSOR 1

Description: A heated oxygen sensor (HO2S) indicating lean at the end of a test is trying to correct for an over-rich condition. This DTC sets when the fuel control system no longer detects switching for a calibrated amount of time.
Possible Causes: Electrical: Universal HO2S harness short to voltage Water in the harness connector UO2SPC circuit open Corrosion Incorrect connections Damaged universal HO2S Fuel System: Excessive fuel pressure Leaking or contaminated fuel injectors Leaking fuel pressure regulator Low fuel pressure or running out of fuel EVAP system Intake Air System: Air leaks after the mass air flow (MAF) sensor Vacuum leaks Positive crankcase ventilation (PCV) system is leaking or the valve is stuck open Incorrectly seated engine oil dipstick Exhaust Gas Recirculation (EGR) System: Leaking gasket Stuck EGR valve Base Engine: Oil overfill Camshaft timing Cylinder compression Exhaust leaks before or near the universal HO2S
Diagnostic Aids:
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST H .