Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Fusion Hybrid >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Electronic Engine Controls - 2.5L (Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal

Powertrain Control Module (PCM): Removal

  1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
  3. Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
  4. Disconnect the vacuum hose from the vacuum brake booster.
    Fig 1: View Of Vacuum Hose End Of Vacuum Brake Booster
    G08022617Courtesy of FORD MOTOR CO.
  5. Disconnect the 3 PCM electrical connectors.
  6. Remove the ground strap bolt and disconnect the ground strap retainer.
    Fig 2: View Of Ground Strap Bolt And Ground Strap Retainer
    G08022618Courtesy of FORD MOTOR CO.
  7. Remove the two LH splash shield pin-type retainers and position the LH splash shield aside.
    Fig 3: View Of LH Splash Shield Pin-Type Retainers
    G08022619Courtesy of FORD MOTOR CO.
  8. Remove the lower PCM bolt and the upper PCM bracket bolt.
    • Remove the PCM.
  9. Remove the upper PCM bolt and the PCM bracket from the PCM.
scientia non olet · About Mike's Workshop Manuals