Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Ford >> 2012 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Ignition - 2.0L DURATEC-He >> Removal and Installation >> Ignition Coil-On-Plug >> Installation

Ignition Coil-On-Plug: Installation

    NOTE: Visual check. Inspect the ignition coil-on-plug rubber boot assembly for cracks, rips, or tears. Replace any damaged ignition coil-on-plug rubber boots.
    Fig 1: Inspecting Ignition Coil-On-Plug Rubber Boot Assembly For Cracks Or Rips
    G08063943Courtesy of FORD MOTOR CO.
  1. To install, slide the new ignition coil-on-plug boot onto the ignition coil until it is fully seated at the top of the ignition coil-on-plug.
  2. To install, reverse the removal procedure.
scientia non olet · About Mike's Workshop Manuals