Anti-Theft - Without Intelligent Access (IA)

INSTRUMENT PANEL CLUSTER (IPC) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC	Description	Action
B10D5:94	PATS Antenna: Unexpected Operation	The IPC received an incomplete or corrupt response from the transceiver. INSTALL a new transceiver, REFER to Passive Anti-Theft System (PATS) Transceiver .
B10D7:05	PATS Key: System Programming Failure	GO to Pinpoint Test A .
B10D7:51	PATS Key: Not Programmed	There is an unprogrammed PATS key. PROGRAM the PATS key. REFER to Key Programming - Program a Key Using Two Programmed Keys or Key Programming Using Diagnostic Equipment .
B10D7:81	PATS Key: Invalid Serial Data Received	GO to Pinpoint Test B .
B10D7:87	PATS Key: Missing Message	GO to Pinpoint Test C .
B10D7:94	PATS Key: Unexpected Operation	GO to Pinpoint Test B .
B10D8:00	PATS Key Less Than Minimum Programmed: No Sub Type Information	Less than 2 keys are programmed into the IPC. CYCLE the customer's second key in the ignition to program (when less than 2 keys are programmed, the IPC automatically programs the first 2 keys that are cycled in the ignition).
B10DA:51	PATS Target Identifier: Not Programmed	There is no PCM ID stored in the IPC. CARRY OUT a parameter reset. REFER to Passive Anti-Theft System (PATS) Parameter Reset . CLEAR the DTCs. REPEAT the self-test.
B10DA:62	PATS Target Identifier: Signal Compare Failure	The PCM ID received by the IPC does not match the ID stored in the IPC memory. CARRY OUT a parameter reset. REFER to Passive Anti-Theft System (PATS) Parameter Reset . CLEAR the DTCs. REPEAT the self-test.
All other DTCs	-	REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .

PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC	Description	Action
U0167:00	Lost Communication With Vehicle Immobilizer Control Module: No Sub Type Information	GO to Pinpoint Test D .
U0426:00	Invalid Data Received From Vehicle Immobilizer Control Module: No Sub Type Information	GO to Pinpoint Test D .
All other DTCs	-	REFER to ELECTRONIC ENGINE CONTROLS .